Satellite Switch: Inspection

INSPECT SATELLITE SWITCH

Measure the resistance between the terminals according to the value(s) in the table below.

Fig 1: Identifying Satellite Switch

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard resistance

SATELLITE SWITCH

Tester Connection	Condition	Specified Condition
J16-2 (LSET) - J16-5 (E)	Satellite switch LH is pressed	Below 1 Ω
J16-2 (LSET) - J16-5 (E)	Satellite switch LH is not pressed	10 kΩ or higher
J16-3 (SET) - J16-5 (E)	Satellite switch ON/ OFF is pressed	Below 1 Ω
J16-3 (SET) - J16-5 (E)	Satellite switch ON/OFF is not pressed	10 kΩ or higher
J16-4 (RSEL) - J16-5 (E)	Satellite switch RH is pressed	Below 1 Ω
J16-4 (RSEL) - J16-5(E)	Satellite switch RH is not pressed	10 kΩ or higher

HINT:

If the value is not as specified, replace the satellite switch.