4WD Control Ecu: Installation

WARNING: This page is about a different car, the 2007 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL 4WD CONTROL ECU
1. Connect the connector and clamp to the 4WD control ECU.
  
  Fig 1: Identifying 4WD Control ECU Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 4WD control ECU with the bolt and nut.
  Torque:
  
  Bolt 14 N*m (137 kgf*cm, 10 ft.*lbf)
  
  Nut 6.0 N*m (61 kgf*cm, 54 in.*lbf)
  
  Fig 2: Identifying 4WD Control ECU With Bolt And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the junction connector with the 2 clips.
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL SIDE INSTRUMENT PANEL RH (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM COVER RH (See INSTALLATION )

Fig 3: Identifying Junction Connector With Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR SCUFF PLATE RH (w/o Illumination)
HINT:

Use the same procedures for the RH side and the LH side (See INSTALLATION ).
INSTALL FRONT DOOR SCUFF PLATE RH (w/ Illumination)
HINT:

Use the same procedures for the RH side and the LH side (See INSTALLATION ).