LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> IS 350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Transfer Case) >> Transfer Control Solenoid >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transfer Control Solenoid: Installation

WARNING: This page is about a different car, the 2007 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSFER CONTROL SOLENOID 
    1. Install the transfer control solenoid and solenoid lock plate to the transfer upper valve body with the bolt.

      Torque: 6.4 N*m (65 kgf*cm, 57 in.*lbf) 

      HINT:

      Install the solenoid lock plate into the cutout on the transfer control solenoid.

      Fig 1: Identifying Solenoid Lock Plate With Bolt
      G05295914Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL TRANSFER VALVE BODY ASSEMBLY (See  INSTALLATION   ) 
  3. INSTALL TRANSFER OIL PAN (See  INSTALLATION   ) 
  4. INSTALL TRANSFER DYNAMIC DAMPER (See  INSTALLATION   ) 
  5. INSTALL ENGINE REAR MOUNTING MEMBER (See  INSTALLATION   ) 
  6. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR (See  INSTALLATION  ) 
  7. INSTALL FRONT EXHAUST PIPE ASSEMBLY (See  INSTALLATION (For 2GR-FSE) INSTALLATION (For 4GR-FSE)  ) 
  8. INSTALL HEATED OXYGEN SENSOR (See  INSTALLATION (For 2GR-FSE) INSTALLATION (For 4GR-FSE)  ) 
  9. INSTALL FRONT CENTER FLOOR BRACE (See  INSTALLATION (For 2GR-FSE) INSTALLATION (For 4GR-FSE)  ) 
  10. INSTALL REAR NO. 1 FLOOR PANEL BRACE (See  INSTALLATION (For 2GR-FSE) INSTALLATION (For 4GR-FSE)  ) 
  11. ADD AUTOMATIC TRANSMISSION FLUID (See  INSTALLATION  ) 
  12. CHECK FOR EXHAUST GAS LEAKS 
scientia non olet · About LEMON Manuals