LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> IS 350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Transfer Case) >> Transfer Valve Body Assembly >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transfer Valve Body Assembly: Installation

WARNING: This page is about a different car, the 2007 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSFER CONTROL SOLENOID (See  REASSEMBLY   ) 
  2. INSTALL TRANSFER VALVE BODY ASSEMBLY 
    1. Connect the transfer wire connector to the transfer control solenoid.
    2. Install the transfer upper valve body with the 4 bolts.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

      Fig 1: Identifying Transfer Wire Connector With Bolts
      G05295959Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL TRANSFER OIL PAN (See  INSTALLATION   ) 
  4. INSTALL TRANSFER DYNAMIC DAMPER (See  INSTALLATION   ) 
  5. INSTALL ENGINE REAR MOUNTING MEMBER (See  INSTALLATION   ) 
  6. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR (See  INSTALLATION  ) 
  7. INSTALL FRONT EXHAUST PIPE ASSEMBLY (See  INSTALLATION (For 2GR-FSE) INSTALLATION (For 4GR-FSE)  ) 
  8. INSTALL HEATED OXYGEN SENSOR (See  INSTALLATION (For 2GR-FSE) INSTALLATION (For 4GR-FSE)  ) 
  9. INSTALL FRONT CENTER FLOOR BRACE (See  INSTALLATION (For 2GR-FSE) INSTALLATION (For 4GR-FSE)  ) 
  10. INSTALL REAR NO. 1 FLOOR PANEL BRACE (See  INSTALLATION (For 2GR-FSE) INSTALLATION (For 4GR-FSE)  ) 
  11. ADD AUTOMATIC TRANSMISSION FLUID (See  INSTALLATION  ) 
  12. CHECK FOR EXHAUST GAS LEAKS 
scientia non olet · About LEMON Manuals