LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> IS 350 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle >> Torque Converter And Drive Plate >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Torque Converter And Drive Plate: Installation

  1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY (See  INSTALLATION   ) 
  2. INSTALL TRANSMISSION OIL COOLER (See  INSTALLATION   ) 
  3. INSTALL TRANSMISSION CONTROL SHAFT LEVER RH (See  INSTALLATION   ) 
  4. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR (See  INSTALLATION   ) 
  5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (See  INSTALLATION   ) 
  6. INSTALL WATER BYPASS HOSE (See  INSTALLATION   ) 
  7. INSTALL WIRE HARNESS (See  INSTALLATION   ) 
  8. CONNECT CONNECTOR (See  INSTALLATION   ) 
  9. INSTALL ENGINE REAR MOUNTING MEMBER (See  INSTALLATION   ) 
  10. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY (See  INSTALLATION   ) 
  11. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT (See  INSTALLATION   ) 
  12. INSTALL FLYWHEEL HOUSING SIDE COVER (See  INSTALLATION   ) 
  13. INSTALL STARTER ASSEMBLY (See  INSTALLATION  ) 
  14. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (See  INSTALLATION  ) 
  15. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (See  INSTALLATION  ) 
  16. FULLY TIGHTEN NO. 1 CENTER SUPPORT BEARING ASSEMBLY (See  REAR PROPELLER SHAFT ASSEMBLY (FOR 4GR-FSE)  ) 
  17. INSPECT AND ADJUST NO. 2 AND NO. 3 JOINT ANGLE (See  REAR PROPELLER SHAFT ASSEMBLY (FOR 4GR-FSE)  ) 
  18. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR (See  INSTALLATION  ) 
  19. INSTALL OUTSIDE AIR GUIDE PLATE RH (See  INSTALLATION  ) 
  20. INSTALL FRONT EXHAUST PIPE ASSEMBLY (See  INSTALLATION  ) 
  21. INSTALL OXYGEN SENSOR (See  INSTALLATION  ) 
  22. INSTALL FRONT CENTER FLOOR BRACE (See  INSTALLATION  ) 
  23. INSTALL NO. 1 REAR FLOOR PANEL BRACE (See  INSTALLATION  ) 
  24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  25. ADD COOLANT 

    (See COOLANT )

  26. ADD AUTOMATIC TRANSMISSION FLUID 

    (See ADJUSTMENT  )

  27. ADJUST COOLANT 

    (See COOLANT )

  28. CHECK FOR ENGINE COOLANT LEAKS (See  COOLANT  ) 
  29. ADJUST SHIFT LEVER POSITION (See  ADJUSTMENT   ) 
  30. INSPECT SHIFT LEVER POSITION (See  ON-VEHICLE INSPECTION   ) 
  31. CHECK FOR EXHAUST GAS LEAKS (See  INSTALLATION  ) 
  32. INSTALL NO. 2 ENGINE UNDER COVER 
  33. INSTALL ENGINE UNDER COVER 
  34. INSTALL ENGINE ROOM SIDE COVER LH (See  INSTALLATION  ) 
  35. INSTALL COOL AIR INTAKE DUCT SEAL (See  INSTALLATION  ) 
  36. RESET MEMORY 

    (See INITIALIZATION  )

  37. PERFORM INITIALIZATION 

    Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).

scientia non olet · About LEMON Manuals