Inspection Procedure

1. Check for DTCs.

   Result: 

   FOR DTC
   
   

   Result	Proceed to
   B2311 is output	A
   B2312 is output	B
   B2313 is output	C
   LIN communication system DTC output reoccur	D
   DTC is not output	E

A: GO TO  DTC B2311  

B: GO TO  DTC B2312  

C: GO TO  DTC B2313  

D: GO TO LIN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

E: GO TO NEXT STEP 

1. Check that the manual UP/DOWN function using the power window regulator switch can operate the driver door power window.

   OK: Manual UP/DOWN function operates normally. 

NG: OTHER PROBLEM (See  REAR POWER WINDOW LH DOES NOT OPERATE WITH REAR POWER WINDOW SWITCH LH   ) 

OK: GO TO NEXT STEP 

1. Use the Data List to check if the power window regulator motor is functioning properly.
   1. Intelligent tester

      RL DOOR MOTOR: 

      INTELLIGENT TESTER RL DOOR MOTOR
      
      

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      RL P/W AUTO SW	Rear power window LH remote auto UP/DOWN switch signal / ON or OFF	ON: Rear power window LH remote auto UP/DOWN switch on master switch operated OFF: Rear power window LH switch on master switch not operated	-

   2. Techstream

      RL-Door Motor: 

      TECHSTREAM RL DOOR MOTOR
      
      

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      RL Door P/W Auto SW	Rear power window LH remote auto UP/DOWN switch signal / ON or OFF	ON: Rear power window LH remote auto UP/DOWN switch on master switch operated OFF: Rear power window LH switch on master switch not operated	-

      OK: Tester display changes normally when rear power window switch LH is operated. 

NG: Go to step 4 

OK: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (for Rear LH) (See  REMOVAL   ) 

1. Disconnect the N6 switch connector.
2. Disconnect the N3 motor connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   REAR SWITCH LH - REAR MOTOR LH
   
   

   Tester Connection	Condition	Specified Condition
   O18-4 (AUTO)-O19-4 (AUTO)	Always	Below 1 Ω
   O18-4 (AUTO) or O19-4 (AUTO) - Body ground	Always	10 kΩ or higher

   Fig 1: Checking Harness And Connector (Rear Switch LH - Rear Motor LH)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

OK: GO TO NEXT STEP 

1. Remove the switch.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR REAR LH)
   
   

   Tester Connection	Switch Condition	Specified Condition
   O18-4 (AUTO)-O18-5 (GND)	AUTO UP/DOWN operation	Below 1 Ω

   Fig 2: Inspecting Power Window Regulator Switch Assembly (For Rear LH)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Rear LH) (See  REMOVAL   ) 

OK: REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (for Rear LH) (See  REMOVAL   )