Inspection Procedure

1. Disconnect the A69 ECU connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   VOLTAGE SPECIFIED CONDITION
   
   

   Tester Connection	Switch Condition	Specified Condition
   A69-12 (STSW) - Body ground	Engine switch on (IG) → cranking	Below 1 V → 8 to 14 V

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (PASSENGER SIDE JUNCTION BLOCK - MAIN BODY ECU) 

Fig 1: Identifying A69 ECU Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: REPLACE PASSENGER SIDE JUNCTION BLOCK (ELECTRIC POWER CONTROL ECU)