Confirmation Driving Pattern

HINT:

Performing this confirmation pattern will activate the mass air flow performance monitor.

Fig 1: Identifying Confirmation Driving Pattern

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the Intelligent tester or Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the tester ON.
4. Clear DTCs (see DTC CHECK / CLEAR ).
5. Start the engine, and warm it up until the engine coolant temperature reaches 70°C (158°F) or higher.
6. Drive the vehicle at approximately 62 mph (100 km/h) for 20 seconds or more.
7. On the tester, enter the following menus:
   1. Intelligent tester - Select: DIAGNOSIS / ENHANCED OBD II / DTC INFO / PENDING CODES; then check if any DTCs (any pending DTCs) are set.
   2. Techstream - Select: Powertrain / Engine / Trouble Codes / Pending; then check if any DTCs (any pending DTCs) are set.