Sleep mode activation
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- BCM receives the sleep-ready signal (ready) from IPDM E/R and combination meter via CAN communication.
- BCM transmits the sleep wake up signal (sleep) to each unit when all of the CAN sleep conditions are fulfilled.
- Each unit stops the transmission of CAN communication with the sleep wake up signal. BCM is in CAN communication sleep mode.
- BCM is in the low power consumption mode and perform the low power consumption control when all of the BCM sleep conditions are fulfilled with CAN sleep condition.
SLEEP MODE ACTIVATION REFERENCE CHART
| Sleep condition |
| CAN sleep condition |
BCM sleep condition |
- Receiving the sleep-ready signal (ready) from all units
- Ignition switch: OFF
- Vehicle security system alarm and panic alarm: No operation
- Warning lamp: Not operation
- Intelligent Key system buzzer: No operation
- Trunk room lamp switch status: No change
- Brake switch: OFF
- Key slot status: No change
- Turn signal indicator lamp: No operation
- Exterior lamp: OFF
- Door lock status: No change
- CONSULT-III communication status: No communication
- Meter display signal: Non-transmission
- Electronic steering column lock operation: No operation
- Door switch status: No change
- Rear window defogger: OFF
|
- Interior room lamp battery saver: Time out
- RAP system: OFF
- Power window switch communication: No transmission
- Push-button ignition switch (push switch) illumination: OFF
- NATS: No operation
- Remote keyless entry receiver communication status: No communication
- Tire pressure monitor system: Stop
|