Inspection Procedure

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF.
Connect GST to data link connector (2), which is located under LH dash panel near the hood opener handle.
- Brake pedal (1)
Turn ignition switch ON.

Fig 1: Identifying Data Link Connector And Brake Pedal
Courtesy of NISSAN MOTOR CO., U.S.A.
Enter the program according to instruction on the screen or in the operation manual.
(*: Regarding GST screens in this section, sample screens are shown.)

Fig 2: GST Sample Screens Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Perform each diagnostic service according to each service procedure.
For further information, see the GST Operation Manual of the tool maker.

Fig 3: Generic Scan Tool Screen Display - READINESS TESTS
Courtesy of NISSAN MOTOR CO., U.S.A.