Component Inspection

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ELECTRONIC CONTROLLED ENGINE MOUNT CONTROL SOLENOID VALVE

With CONSULT-III

Turn ignition switch OFF.
Reconnect electronic controlled engine mount control solenoid valve harness connector.
Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.
Turn ignition switch ON.
Select "ENGINE MOUNTING" in "ACTIVE TEST" mode with CONSULT-III.

Check air passage continuity and operation delay time under the following conditions.

CONTINUITY CHART

Condition (ENGINE MOUNTING)	Air passage continuity between (A) and (B)	Air passage continuity between (A) and (C)
TRVL	Existed	Not existed
IDLE	Not existed	Existed

Fig 1: Checking Air Passage Continuity

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-III

Turn ignition switch OFF.
Disconnect electronic controlled engine mount control solenoid valve harness connector.
Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.

Check air passage continuity and operation delay time under the following conditions.

CONTINUITY CHART

Condition	Air passage continuity between (A) and (B)	Air passage continuity between (A) and (C)
12 V direct current supply between terminals 1 and 2	Existed	Not existed
No supply	Not existed	Existed

Fig 2: Checking Air Passage Continuity

Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES: INSPECTION END

NO: Replace electronic controlled engine mount control solenoid valve.