LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LS 460 >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Suspension Control >> Rear Acceleration Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Acceleration Sensor: Removal

  1. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
  3. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE ROPE HOOK ASSEMBLY  (See REMOVAL )
  5. REMOVE ROPE HOOK  (See REMOVAL )
  6. REMOVE DECK TRIM SIDE BOARD RH  (See REMOVAL )
  7. REMOVE LUGGAGE COMPARTMENT NO. 1 LIGHT ASSEMBLY  (See REMOVAL )
  8. REMOVE LUGGAGE COMPARTMENT NO. 2 TRIM HOOK (w/o Rear Cooler)  (See REMOVAL )
  9. REMOVE LUGGAGE COMPARTMENT TRIM COVER FRONT  (See REMOVAL )
  10. REMOVE REAR FLOOR FINISH PLATE  (See REMOVAL )
  11. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH  (See REMOVAL )
  12. REMOVE ACCELERATION SENSOR ASSEMBLY 
    1. Disconnect the connector.
    2. Remove the bolt and sensor with bracket.
      Fig 1: Identifying Acceleration Sensor Assembly
      G04944240Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Avoid any impact to the suspension control acceleration sensor.
      • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
      • The acceleration sensor removed from the vehicle must not be placed upside down.
scientia non olet · About LEMON Manuals