Front Stabilizer Bar: Removal

1. Remove the 8 bolts and the No. 2 engine under cover.
   Fig 1: Locating Bolts And No. 2 Engine Under Cover

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 nuts and the front stabilizer link.

   HINT:

   If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

Fig 2: Locating Nuts And Front Stabilizer Link
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Remove the RH side following the same procedures as the LH side.

1. Remove the 2 screws and the engine under cover sub-assembly LH from the front suspension member reinforcement LH.
   Fig 3: Locating Screws And Engine Under Cover Sub-Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Remove the RH side following the same procedures as the LH side.

1. Remove the 2 screws and the engine under cover rear LH.

Fig 4: Locating Engine Under Cover Rear LH Screws

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Remove the RH side following the same procedures as the LH side.

1. Remove the 2 bolts and the front No. 1 stabilizer bracket LH from the front suspension crossmember.
   Fig 5: Locating Front No. 1 Stabilizer Bracket Bolts LH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Remove the RH side following the same procedures as the LH side.

1. Remove the front stabilizer bar from the vehicle.

1. Remove the 2 front No. 1 stabilizer bar bushes from the front stabilizer bar.

1. Remove the 4 bolts and front suspension member reinforcement LH from the vehicle.

Fig 6: Locating Front Suspension Member Reinforcement Bolts LH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Remove the RH side following the same procedures as the LH side.