LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LS 460 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle >> Floor Shift Assembly >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Floor Shift Assembly: Removal

  1. REMOVE COWL TOP VENTILATOR LOUVER  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
  3. REMOVE CONSOLE BOX ASSEMBLY 
    1. Remove the console box (see REMOVAL ).
  4. REMOVE NO. 1 CONSOLE BOX DUCT 
    1. Remove the 2 screws and pull out the duct.
  5. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    Fig 1: Locating Floor Shift Gear Shifting Rod Nut
    G04948456Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Move the shift lever to the N position.
    2. Remove the nut and disconnect the shifting rod from the connecting rod swivel.
  6. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY 
    Fig 2: Locating Transmission Floor Shift Bolts And Wire Harness Clamps
    G04948529Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the 2 connectors.
    2. Disconnect the 5 wire harness clamps from the floor shift.
    3. Remove the 4 bolts and floor shift.
scientia non olet · About LEMON Manuals