Cruise Control Main Switch: Removal

REMOVE COWL TOP VENTILATOR LOUVER LH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE SWITCH AND VOLUME CASE (See REMOVAL )
REMOVE NO. 2 STEERING WHEEL COVER LOWER (See REMOVAL )
REMOVE STEERING PAD (See REMOVAL )
REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY
1. Disconnect the connector and clamp.
  
  Fig 1: Locating Connector And Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 screws.
  
  Fig 2: Locating Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the switch.
  
  Fig 3: Locating Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002