LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LS 460L >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control >> Dynamic Radar Cruise Control System >> Cruise Main Indicator Light Circuit >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

  1. PERFORM ACTIVE TEST BY INTELLIGENT TESTER OR TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT) 
    1. Select the ACTIVE TEST, use the intelligent tester or Techstream to generate a control command, and then check that the combination meter operates.
      1. Intelligent tester

        METER 

        INTELLIGENT TESTER - METER

        Tester Display Test Part Control Range Diagnostic Note
        CRUISE INDIC CRUISE main indicator light ON / OFF -
      2. Techstream

        Combination Meter 

        TECHSTREAM - COMBINATION METER

        Tester Display Test Part Control Range Diagnostic Note
        Indic. Lamp Cruise CRUISE main indicator light ON / OFF -

        OK: Indicator light turns on. 

    NG: GO TO METER / GAUGE SYSTEM  (See PROBLEM SYMPTOMS TABLE )

    OK: GO TO NEXT STEP 

  2. READ VALUE OF INTELLIGENT TESTER OR TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT) 
    1. Check the DATA LIST for proper functioning of the CRUISE main indicator light.
      1. Intelligent tester

        CCS 

        INTELLIGENT TESTER - CCS

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        CCS READY M-CPU Cruise control system standby condition (Main CPU)/ON or OFF ON: Cruise control main switch (Main CPU) is SET
        OFF: Cruise control main switch (Main CPU) is UNSET
        -
        CCS INDICATOR M-CPU Cruise indicator signal (Main CPU)/ON or OFF ON: CRUISE main indicator light is ON
        OFF: CRUISE main indicator light is OFF
        -
      2. Techstream

        Cruise Control 

        TECHSTREAM - CRUISE CONTROL

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        CCS Ready M-CPU Cruise control system standby condition (Main CPU)/ON or OFF ON: Cruise control main switch (Main CPU) is SET
        OFF: Cruise control main switch (Main CPU) is UNSET
        -
        CCS Indicator M-CPU Cruise indicator signal (Main CPU)/ON or OFF ON: CRUISE main indicator light is ON
        OFF: CRUISE main indicator light is OFF
        -

        OK: When cruise control main switch operation is performed, the result will be same as above. 

    NG: REPLACE ECM  (See REMOVAL )

    OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE   )