How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the front power seat control system.
• *: Use the intelligent tester or Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the intelligent tester or Techstream to check if the CAN communication system is functioning normally.

      Result 

      COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

   B: Go to CAN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

   A: GO TO NEXT STEP 

4. CHECK FOR DTC* 
   1. Check for DTCs (see DTC CHECK / CLEAR  )
   2. Clear the DTCs (see DTC CHECK / CLEAR  )
   3. Recheck for DTCs (see DTC CHECK / CLEAR  )

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      DTC does not reoccur	A
      DTC reoccurs	B

   B: Go to step   7 

   A: GO TO NEXT STEP 

5. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms	B

   B: Go to step   7 

   A: GO TO NEXT STEP 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. DATA LIST / ACTIVE TEST (see DATA LIST / ACTIVE TEST  )
   2. Terminals of ECU (see TERMINALS OF ECU  )
   3. Operation Check (see OPERATION CHECK  )
7. ADJUST, REPAIR OR REPLACE 
8. CONFIRMATION TEST 

   NEXT: END