April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

REMOVE FRONT WHEEL
DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH (See REMOVAL )
REMOVE FRONT DISC (See REMOVAL )
INSPECT FRONT AXLE HUB BEARING LOOSENESS

Fig 1: Measuring Looseness Near Center Of Axle Hub
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Using a dial indicator, measure the looseness near the center of the axle hub.
  Maximum:
  
  0.05 mm (0.0020 in.)
  
  NOTE: Ensure that the dial indicator is set at a right angle to the measurement surface.
  
  If the looseness exceeds the maximum, replace the axle hub.

Fig 2: Measuring Runout On Surface Of Axle Hub Outside Hub Bolt

G04944019

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSPECT FRONT AXLE HUB RUNOUT
1. Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.
  Maximum:
  
  0.05 mm (0.0020 in.)
  
  NOTE: Ensure that the dial indicator is set at a right angle to the measurement surface.
  
  If the runout exceeds the maximum, replace the axle hub.
INSTALL FRONT DISC (See INSTALLATION )
CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT WHEEL
Torque: 140 N*m (1428 kgf*cm, 103 ft.*lbf)