Steering Knuckle: Installation

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (SS-2).

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH (See  REMOVAL   ) 
2. INSTALL STEERING KNUCKLE SUB-ASSEMBLY LH (See  INSTALLATION   ) 
3. CONNECT FRONT NO. 2 SUSPENSION LOWER ARM ASSEMBLY LH (See  INSTALLATION   ) 
4. CONNECT FRONT SHOCK ABSORBER ASSEMBLY LH (See  INSTALLATION   ) 
5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH (See  INSTALLATION   ) 
6. CONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (See  INSTALLATION   ) 
7. CONNECT FRONT NO. 1 SUSPENSION LOWER ARM ASSEMBLY LH (See  INSTALLATION   ) 
8. CONNECT TIE ROD ASSEMBLY LH  (See INSTALLATION )
9. INSTALL FRONT DISC BRAKE DUST COVER LH (See  INSTALLATION   ) 
10. INSTALL FRONT DISC  (See INSTALLATION )
11. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH (See  INSTALLATION   ) 
12. CONNECT SPEED SENSOR CONNECTOR LH (See  INSTALLATION   ) 
13. INSTALL FRONT WHEEL 
14. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT (See  INSTALLATION   ) 
15. CHECK ABS SPEED SENSOR SIGNAL 
    1. Check the speed sensor signal (BC-46).
16. VEHICLE PREPARATION FOR HEADLIGHT AIMING ADJUSTMENT  (See ADJUSTMENT )
17. PREPARATION FOR HEADLIGHT AIMING (Using a screen)  (See ADJUSTMENT )
18. HEADLIGHT AIMING INSPECTION  (See ADJUSTMENT )
19. HEADLIGHT AIMING ADJUSTMENT  (See ADJUSTMENT )
20. ADJUST OBJECT RECOGNITION CAMERA 
    1. Adjust the object recognition camera (see ADJUSTMENT ).