LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LS 460L >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Source / Wiring >> Battery Current Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Battery Current Sensor: Removal

  1. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
  3. REMOVE ENGINE ROOM SIDE COVER RH  (See REMOVAL )
  4. REMOVE FRONT FENDER PROTECTOR UPPER RH  (See REMOVAL )
  5. REMOVE BATTERY CURRENT SENSOR 
    1. Disconnect the connector from the battery current sensor assembly.
    2. Remove the bolt, ground terminal and battery current sensor assembly.
    3. Remove the battery current sensor assembly from the ground terminal.
      Fig 1: Locating Bolt
      G04945747Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals