On-Vehicle Inspection

REMOVE COWL TOP VENTILATOR LOUVER RH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE FUEL PUMP RELAY (F/PMP)
1. Remove the fuel pump relay from the engine room No. 2 relay block.

INSPECT FUEL PUMP RELAY

Measure the resistance according to the value(s) in the table below.

Standard resistance

FUEL PUMP RELAY

Tester Connection	Condition	Specified Condition
3 - 4	when no battery voltage is applied to terminals 1 and 2	Below 1 Ω
3 - 4	when battery voltage is applied to terminals 1 and 2	10 kΩ or higher

Fig 1: Inspecting Fuel Pump Relay

If the result is not as specified, replace the relay.

INSTALL FUEL PUMP RELAY
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSTALL COWL TOP VENTILATOR LOUVER RH (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.