Illumination Signal Check For NAVI Control Unit

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ILLUMINATION SIGNAL

Turn the ignition switch ON.
Check voltage between NAVI control unit and ground.

VOLTAGE SPECIFICATION

Terminals			Lighting switch position
(+)		(-)
Connector	Terminal (Wire color)		1st or 2nd position	OFF
P107	25 (R/L)	Ground	Battery voltage	Approx. 0V

OK or NG

OK: Replace NAVI control unit. Refer to REMOVAL AND INSTALLATION OF NAVI CONTROL UNIT .
NG: Check harness for open or short between NAVI control unit and IPDM E/R.

Fig 1: Checking Voltage Between NAVI Control Unit And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.