Diagnostic Trouble Codes Confirmation Procedure: Notes
WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- If the target idle speed is out of the specified value, perform Idle Air Volume Learning, OPERATION PROCEDURE before conducting DTC Confirmation Procedure. For the target idle speed, refer to the "SERVICE DATA AND SPECIFICATIONS (SDS) ",
TESTING CONDITION:
- Before performing the following procedure, confirm that battery voltage is more than 11V at idle.
- Always perform the test at a temperature above -10°C (14°F).