Transfer Control Unit Terminals And Reference Value
WARNING: This page is about a different car, the 2006 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
Data are reference value and are measured between each terminal and ground.
TRANSFER CONTROL UNIT TERMINALS AND REFERENCE VALUE
| Terminal | Wire color | Item | Condition | Data (Approx.) |
|---|---|---|---|---|
| 25 | L/W | Ignition switch monitor | Ignition switch: ON | Battery voltage |
| Ignition switch: OFF | 0V | |||
| 27 | Y/R | Actuator motor power supply | Ignition switch: ON | Battery voltage |
| Ignition switch: OFF (5 seconds after ignition switch is turned OFF.) |
0V | |||
| 32 | B | Actuator motor ground | Always | 0V |
| 40 | Y | Transfer shut off relay | Ignition switch: ON | 0V |
| Ignition switch: OFF (5 seconds after ignition switch is turned OFF.) |
Battery voltage |
CAUTION:
When using a circuit tester to measure voltage for inspection, be sure not to extend forcibly any connector terminals.