Setting Change Function
WARNING: This page is about a different car, the 2006 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
The settings of the automatic driving positioner system can be changed, using CONSULT-II and the display in the center of the instrument panel.
AUTOMATIC DRIVING POSITIONER SETTING CHANGE FUNCTION
| x: Applicable -: Not applicable | |||||
|---|---|---|---|---|---|
| Setting item | Content | CONSULT-II (WORK SUPPORT) | Display unit | Default setting | Factory setting |
| SEAT SLIDE VOLUME SET |
The distance at exiting operation can be selected from the following 3 modes. | 40 mm | - | x | x |
| 80 mm | - | - | |||
| 150 mm | - | - | |||
| Sliding Front Seat When Entry/ Exiting Vehicle | The seat sliding turnout and return at entry/exit can be selected: ON (operated)-OFF (not operated) | ON | ON: Indicator lamp ON | - | x |
| OFF | OFF: Indicator lamp OFF | x | - | ||
| Reset custom settings* | All settings to default. | - | Default: Setting button ON | - | - |
It is possible to set sliding front seat for entry/exit of vehicle by pressing set switch.
SLIDING FRONT SEAT FOR ENTRY/EXIT SETTING CHANGE FUNCTION
| Content | Setting change operation | Indicator LEDs |
|---|---|---|
| The seat sliding turnout and return at entry/exit can be operated. | Press the set switch for more than 10 seconds | Blinking twice |
| The seat sliding turnout and return at entry/exit can be not operated. | Blinking once | |
| *: Setting of sliding front seat for entry/exit of vehicle is ON at factory-shipment. But if custom settings are reset, setting turns OFF. | ||
NOTE:
After the setting is registered, the new setting is effective, even if the battery is disconnected.