Section 387 (Driver Information System)
WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Precaution
- Preparation
- Combination Meters
- System Description
- Component Parts and Harness Connector Location
- Combination Meter
- Circuit Diagram
- Wiring Diagram - METER -
- Terminals and Reference Value for Combination Meter
- Meter/Gauge Operation and Odo/Trip Meter
- How to Proceed With Trouble Diagnosis
- Diagnosis Flow
- Power Supply and Ground Circuit Inspection
- Symptom Chart
- Vehicle Speed Signal Inspection
- Water Temperature Signal Inspection
- Engine Speed Signal Inspection
- Fuel Level Sensor Unit Inspection
- Fuel Gauge Fluctuates, Indicates Wrong Value, or Varies
- Fuel Gauge Does Not Move to Full-position
- Electrical Components Inspection
- Warning Lamps
- A/T Indicator
- Warning Chime
- Component Parts and Harness Connector Location
- System Description
- CAN Communication System Description
- Wiring Diagram - CHIME -
- Terminals and Reference Value for BCM
- Terminals and Reference Value for Combination Meter
- How to Proceed With Trouble Diagnosis
- Preliminary Check
- CONSULT-II Function (BCM)
- All Warning Chimes Do Not Operate
- Key Warning Chime and Light Warning Chime Do Not Operate (Seat Belt Warning Chime Does Operate)
- Key Warning Chime Does Not Operate
- Light Warning Chime Does Not Operate
- Seat Belt Warning Chime Does Not Operate
- Rear Sonar System
- Component Parts and Harness Connector Location
- System Description
- Wiring Diagram - SONAR -
- Terminals And Reference Value For Sonar Control Unit
- How to Proceed With Trouble Diagnosis
- Pre-diagnosis Inspection
- Self-diagnosis Function
- Preliminary Check
- Symptom Chart
- Component Inspection
- Rear Sonar Sensors
- Sonar Control Unit
- Rear View Monitor
- Component Parts and Harness Connector Location
- System Description
- Schematic
- Wiring Diagram - R/VIEW -
- Terminals and Reference Value for Rear View Camera Control Unit
- CONSULT-II Function (REARVIEW CAMERA)
- Side Distance Guideline Correction
- Power Supply and Ground Circuit Inspection
- Rear View Is Not Displayed With The A/T Selector Lever In R Position
- Rear View Camera Control Unit
- Rear View Camera