Rear View Camera Operation: Notes

WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

When ignition switch is in ON or START position, power is supplied

through 10A fuse [No. 14, located in the fuse block (J/B)]
to park/neutral position (PNP) switch terminal 2.

When A/T selector lever is in reverse position, power is supplied

through park/neutral position (PNP) switch terminal 4
to rear view camera control unit terminal 4.

Then, rear view camera control unit sends camera ON signal

through rear view camera control unit terminal 8
to rear view camera terminal 1.

An image taken by rear view camera is sent

through rear view camera terminals 3 and 4
to rear view camera control unit terminals 9 and 10.

Then an image is sent

through rear view camera control unit terminals 11 and 12
to display unit terminals 4 and 15.

An image of rear view will be projected on the display.