Operation Procedure
WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Touch "DATA MONITOR" on "SELECT DIAG MODE" screen.
- Touch "ALL SIGNALS""MAIN SIGNALS" or "SELECTION FROM MENU" on the "SELECT MONITOR ITEM" screen.DATA MONITOR TABLE
ALL SIGNALS All items will be monitored. MAIN SIGNALS Monitor the predetermined item. SELECTION FROM MENU Select any item for monitoring. - Touch "START".
- Touch the required monitoring item on "SELECTION FROM MENU". In "ALL SIGNALS", all items are monitored. In "MAIN SIGNALS", predetermined items are monitored.
- Touch "RECORD" while monitoring to record the status of the item being monitored. To stop recording, touch "STOP".
All Items, Main Items, Select Item Menu
ITEM MENU TABLE
| Item name | CONSULT-II screen display | Display or unit | Monitor item selection | Description | ||
|---|---|---|---|---|---|---|
| ALL SIGNALS | MAIN SIGNALS | SELECTION FROM MENU | ||||
| Parking, license plate and tail lamps request | TAIL&CLR REQ | ON/OFF | x | x | x | Signal status input from BCM |
| Headlamp low beam request | HL LO REQ | ON/OFF | x | x | x | Signal status input from BCM |
| Headlamp high beam request | HL HI REQ | ON/OFF | x | x | x | Signal status input from BCM |
| Cornering lamp | CRNRNG LMP REQ | ON/OFF | x | - | x | Signal status input from BCM |
| Front fog lamps request | FR FOG REQ | ON/OFF | x | x | x | Signal status input from BCM |
NOTE:
Perform monitoring of IPDM E/R data with the ignition switch ON. When the ignition switch is at ACC, the display may not be correct.