Steering Angle Sensor: Removal

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Remove the spiral cable. Refer to REMOVAL AND INSTALLATION .
Remove the screws (A) and release clips (B) to remove the steering angle sensor (1) from spiral cable (2).

Fig 1: Identifying Steering Angle Sensor

Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: In the case that the ABS actuator and electronic unit (control unit) is replaced, make sure to adjust position of steering angle sensor. Refer to Adjustment of Steering Angle Sensor Neutral Position .