LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> LS 460L >> Repair and Diagnosis >> External Pages >> Different car >> Section 741 (Engine Control System - Introduction) >> Trouble Diagnosis >> CONSULT-II Function (ENGINE) >> Work Support Mode >> Work Item
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Item

WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
WORK ITEM AND CONDITION

WORK ITEM CONDITION USAGE
FUEL PRESSURE RELEASE
  • FUEL PUMP WILL STOP BY TOUCHING "START" DURING IDLING.

CRANK A FEW TIMES AFTER ENGINE STALLS.		 When releasing fuel pressure from fuel line
IDLE AIR VOL LEARN
  • THE IDLE AIR VOLUME THAT KEEPS THE ENGINE WITHIN THE SPECIFIED RANGE IS MEMORIZED IN ECM.
 When learning the idle air volume
SELF-LEARNING CONT
  • THE COEFFICIENT OF SELF-LEARNING CONTROL MIXTURE RATIO RETURNS TO THE ORIGINAL COEFFICIENT.
 When clearing the coefficient of self-learning control value
ETHANOL M/R ADJ
  • THIS FUNCTION ALLOWS THE ETHANOL MIXTURE RATIO THAT THE ECM ESTIMATED TO BE CHANGED. IMPROPER USAGE OF THIS FUNCTION MAY CAUSE POOR DRIVEABILITY OR DECREASING FUEL ECONOMY. FOLLOW THE INSTRUCTION IN THIS INFORMATION.
 When adjusting the ethanol mixture ratio to the specified value.
WORK ITEM AND CONDITION

WORK ITEM CONDITION USAGE
EVAP SYSTEM CLOSE THE EVAP CANISTER VENT CONTROL VALVE IN ORDER TO MAKE EVAP SYSTEM CLOSE UNDER THE FOLLOWING CONDITIONS.
  • IGN SW ON
  • ENGINE NOT RUNNING
  • AMBIENT TEMPERATURE IS ABOVE 0°C (32°F).
  • NO VACUUM AND NO HIGH PRESSURE IN EVAP SYSTEM
  • FUEL TANK TEMP. IS MORE THAN 0°C (32°F).
  • WITHIN 10 MINUTES AFTER STARTING "EVAP SYSTEM CLOSE"
  • WHEN TRYING TO EXECUTE "EVAP SYSTEM CLOSE" UNDER THE CONDITION EXCEPT ABOVE, CONSULT-II WILL DISCONTINUE IT AND DISPLAY APPROPRIATE INSTRUCTION.
NOTE: WHEN STARTING ENGINE, CONSULT-II MAY DISPLAY "BATTERY VOLTAGE IS LOW. CHARGE BATTERY", EVEN IN USING CHARGED BATTERY.
 When detecting EVAP vapor leak point of EVAP system
VIN REGISTRATION
  • IN THIS MODE, VIN IS REGISTERED IN ECM
 When registering VIN in ECM
TARGET IDLE RPM ADJ (1)
  • IDLE CONDITION
 When setting target idle speed
TARGET IGN TIM ADJ (1)
  • IDLE CONDITION
 When adjusting target ignition timing
(1) This function is not necessary in the usual service procedure.
scientia non olet · About LEMON Manuals