With GST
WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Be sure to read the explanation of Driving Pattern in Fig 1
before driving vehicle.
- Start engine.
- Drive vehicle according to "Driving Pattern" as shown in Fig 1 .
- Stop vehicle.
- Select MODE 1 with GST.
- If SRT of EVAP system is not set yet go to the following step.
- If SRT of EVAP system is set, the result will be OK.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine.
It is not necessary to cool engine down before driving.
- Drive vehicle again according to the "Driving Pattern" as shown in Fig 1 .
- Stop vehicle.
- Select MODE 3 with GST.
- If P0442 is displayed on the screen, go to "DIAGNOSTIC PROCEDURE ".
- If P0441 is displayed on the screen go to DIAGNOSTIC PROCEDURE for DTC P0441, "DIAGNOSTIC PROCEDURE ".
- If P0441 and P0442 are not displayed on the screen, go to the following step.
- Select MODE 1 with GST.
- If SRT of EVAP system is set, the result will be OK.
- If SRT of EVAP system is not set, go to step 6.