Component Function Check

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

START
Check that all of the following conditions are satisfied.
- Vehicle driven distance: More than 5, 000 km (3, 107 miles)
- Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm² , 14.25 - 15.12 psi)
- Atmospheric temperature: 20 - 30°C (68 - 86°F)
- Engine coolant temperature: 75 - 95°C (167 - 203°F)
- Transmission: Warmed-up
  - After the engine is warmed up to normal operating temperature, drive vehicle until "ATF TEMP SEN" in "DATA MONITOR" mode of "CVT" system indicates less than 0.9 V.
- Electrical load: Not applied
  - Rear window defogger switch, air conditioner switch lighting switch are OFF. Steering wheel is straight ahead.
- Engine speed: Idle
: GO TO 2.
PERFORM "SPEC" OF "DATA MONITOR" MODE
With CONSULT-III

NOTE: Perform "SPEC" in "DATA MONITOR" mode in maximum scale display.
1. Perform "BASIC INSPECTION: SPECIAL REPAIR REQUIREMENT ".
2. Select "B/FUEL SCHDL", "A/F ALPHA-B1", "A/F ALPHA-B2" and "MAS A/F SE-B1" in "SPEC" of "DATA MONITOR" mode with CONSULT-III.
3. Check that monitor items are within the SP value.

Is the measurement value within the SP value?

YES: INSPECTION END

NO: Go to "DIAGNOSIS PROCEDURE ".