Front Seat Inner Belt Assembly: Removal

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY  (See REMOVAL )
2. REMOVE FRONT SEAT ASSEMBLY  (See REMOVAL )
3. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
   NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
5. REMOVE FRONT SEAT INNER BELT ASSEMBLY 
   1. for Driver Seat:

      Disconnect the 3 connectors and detach the 5 clamps.

   2. for Passenger Seat:

      Disconnect the 2 connectors and detach the clamp.

      Fig 1: Disconnecting Connectors And Clamps

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the nut and front seat inner belt assembly.
      Fig 2: Identifying Front Seat Inner Belt Assembly Nut

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002