Problem Symptoms Table
HINT:
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Problem symptoms may occur if the electric power control system's functions malfunction. Follow the HOW TO PROCEED WITH TROUBLESHOOTING procedures.
Air suspension system
AIR SUSPENSION SPECIFICATION
| Symptom | Suspected Area | See |
|---|---|---|
| Drivability problem | Air leakage | OPERATION CHECK |
| Front pneumatic cylinder | INSPECTION | |
| Rear pneumatic cylinder | INSPECTION | |
| Check DTC | DTC CHECK / CLEAR | |
| Suspension control ECU | TERMINALS OF ECU | |
| Height control function is normal, but vehicle height is uneven | Initialization | INITIALIZATION |
| Height control sensor link | DTC C1711 FRONT HEIGHT CONTROL SENSOR RH CIRCUIT MALFUNCTION; DTC C1712 FRONT HEIGHT CONTROL SENSOR LH CIRCUIT MALFUNCTION; DTC C1713 REAR HEIGHT CONTROL SENSOR RH CIRCUIT MALFUNCTION; DTC C1714 REAR HEIGHT CONTROL SENSOR LH CIRCUIT MALFUNCTION | |
| Suspension control ECU | TERMINALS OF ECU | |
| When engine switch is turned on (IG), "HEIGHT HIGH" indicator light does not illuminate for approximately 2 seconds | Electric power control system | HOW TO PROCEED WITH TROUBLESHOOTING |
| Ecu power source circuit | ECU POWER SOURCE CIRCUIT | |
| Indicator CIRCUIT | INDICATOR CIRCUIT | |
| When height control switch and absorber control switch are operated, indicator light does not change | Electric power control system | HOW TO PROCEED WITH TROUBLESHOOTING |
| Indicator CIRCUIT | INDICATOR CIRCUIT | |
| When HEIGHT CONTROL SWITCH AND ABSORBER CONTROL SWITCH ARE OPERATED, INDICATOR LIGHT ONLY CHANGES FOR ONE SWITCH | No. 1 console switch | ECU POWER SOURCE CIRCUIT |
| Combination meter | HOW TO PROCEED WITH TROUBLESHOOTING | |
| DTC check cannot be done | CAN communication line | CAN COMMUNICATION SYSTEM |
| Tc and CG terminal circuit | TC AND CG TERMINAL CIRCUIT | |
| Suspension control ECU | TERMINALS OF ECU | |
| Input signal check (test mode) can not be done | CAN communication line | CAN COMMUNICATION SYSTEM |
| Ts and CG terminal circuit | TS AND CG TERMINAL CIRCUIT | |
| Suspension control ECU | TERMINALS OF ECU |