On-Vehicle Inspection

REMOVE FUEL PUMP RELAY (Marking: F/PUMP)
1. Remove the engine room relay block cover.
2. Remove the relay from the engine room relay block.

CHECK FUEL PUMP RELAY

Measure the resistance of the relay.

Standard resistance

RESISTANCE SPECIFICATION

Tester Connection	Specified Condition
3 - 4	Below 1 Ω
3 - 5	10 kΩ or higher
3 - 4	10 kΩ or higher (when battery voltage is applied to terminals 1 and 2)
3 - 5	Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

If the result is not as specified, replace the relay.