Transmission Wire: Inspection

INSPECT TRANSMISSION WIRE

Disconnect the E1 ATF temperature sensor connector from the transmission.

Measure the resistance of the temperature sensor.

Standard resistance

RESISTANCE REFERENCE CHART

Tester Connection	Specified Condition
2 (OT-) -10 (OT+)	79 Ω to 156 kΩ
2 (OT-) - Body ground	1 MΩ or higher
10 (OT+) - Body ground	1 MΩ or higher

HINT:

If the resistance is out of the specified range of either of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.

Fig 1: Identifying E1 ATF Temperature Sensor Connector Terminal

Standard resistance

RESISTANCE REFERENCE CHART

ATF Temperature	Specified Condition
20°C (68°F)	3 to 4 kΩ
110°C (230°F)	0.22 to 0.28 kΩ.