Initialization

INITIALIZATION

NOTE: When disconnecting the cable from negative (-) battery terminal, initialize the system(s) after the terminal is reconnected.

The initialization procedures are shown below.

System Name
Lighting System
Power Door Lock Control System
Power Window Control System
Power Back Door System
Sliding Roof System (for Multi-panel Moon Roof)
Sliding Roof System (for Standard)

POWER DOOR LOCK CONTROL SYSTEM
BACK DOOR LOCK
a. When the battery is reconnected:
If the back door is locked and therefore cannot be opened, it is necessary to unlock the back door using the door control switch or transmitter switch.

b. When the back door lock is replaced:
The power back door ECU cannot receive a switch signal from the lock. This may cause the power back door system to enter fail-safe mode and DTC B2215 to set, as well as to make the system disabled. When the lock is replaced, be sure to perform the following: first properly connect the lock, second clear the DTC from memory using the intelligent tester and finally recheck that no DTC is output.