Inspection Procedure
NOTE:
- When replacing the brake actuator assembly, perform zero point calibration (See CALIBRATION ).
- A road test means accelerating, decelerating, and turning the vehicle safely.
- CHECK ENGINE CONTROL SYSTEM
- Check if an engine control system DTC is output (See DTC CHECK/CLEAR
).
Result
RESULT REFERENCECondition Proceed to Engine control system DTC is not output A Engine control system DTC is output B
B: INSPECT ENGINE CONTROL SYSTEM (See DIAGNOSTIC TROUBLE CODE TABLE )
A: Go to Next Step
- Check if an engine control system DTC is output (See DTC CHECK/CLEAR
).
- REPLACE ECM
- Turn the ignition switch off.
- Replace the ECM (See REMOVAL ).
- RECONFIRM DTC
- Clear the DTC (See DTC CHECK/CLEAR ).
- Perform the road test.
- Check if the same DTC is recorded (See DTC CHECK/CLEAR
).
Result
RESULT REFERENCECondition Proceed to DTC (C1201/51) is output A DTC (C1201/51) is not output B
B: END
A: REPLACE BRAKE ACTUATOR ASSEMBLY (See REMOVAL )