Inspection Procedure
NOTE:
- When replacing the brake actuator assembly, perform zero point calibration (See CALIBRATION ).
- A road test means accelerating, decelerating, and turning the vehicle safely.
- CHECK DTC OUTPUT (FOR ABS SYSTEM)
- Clear the DTCs (See DTC CHECK/CLEAR ).
- Turn the ignition switch to the ON position.
- Perform the road test.
- Check for the DTCs (See DTC CHECK/CLEAR
).
Result
RESULT REFERENCE TABLEResult Proceed to DTC (ABS system) is not output A DTC (ABS system) is output B
B: REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (See DIAGNOSTIC TROUBLE CODE TABLE )
A: Go to Next Step
- CONFIRM DTC OUTPUT (C1223/43)
- Clear the DTCs (See DTC CHECK/CLEAR ).
- Turn the ignition switch to the ON position.
- Check for the DTCs (See DTC CHECK/CLEAR
).
Result
RESULT REFERENCE TABLEResult Proceed to DTC (C1223/43) is not output A DTC (C1223/43) is output B
B: REPLACE BRAKE ACTUATOR ASSEMBLY (See REMOVAL )
A: END