LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 350 AWD >> Repair and Diagnosis >> Electrical >> Starter >> Starting >> Starter >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair and Diagnosis: Electrical: Starter: Starting: Starter: Installation

  1. INSTALL STARTER ASSEMBLY 
    Fig 1: Identifying Starter Assembly Bolts
    G04975667Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N*m (380 kgf*cm, 28 ft.*lbf) 

    2. Connect the wire harness to terminal 30 and install the nut, and then attach the terminal cap.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    3. Connect the terminal 50 connector to the starter assembly.
  2. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL NO. 2 AIR CLEANER INLET  (See INSTALLATION )
  6. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  7. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  (See INSTALLATION )
  9. PERFORM INITIALIZATION 
    1. Perform initialization procedure (See INITIALIZATION ).

      HINT:

      Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.

scientia non olet · About LEMON Manuals