Inspection Procedure

1. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Condition	Specified Condition
   FPR (E7-30) - E1 (E7-1)	STA signal ON	9 to 14V
   FPR (E7-30) - E1 (E7-1)	STA signal OFF	0 to 3V

NG: REPLACE ECM  (See REMOVAL  )

Fig 1: Identifying ECM Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go to Next Step 

1. Remove the FUEL PUMP relay from the engine room R/B.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Specified Condition
   3 - 4	Below 1 Ω
   3 - 5	10 kΩ or higher
   3 - 4	10 kΩ or more (when battery voltage is applied to terminals 1 and 2)
   3 - 5	Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

NG: REPLACE RELAY 

Fig 2: Identifying Fuel Pump Relay Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go to Next Step 

1. Remove the fuel pump relay from the engine room R/B.
2. Disconnect the E7 ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Specified Condition
   FUEL PUMP relay terminal 1 - E7-30 (FPR)	Below 1 Ω
   FUEL PUMP relay terminal 1 or E7-30 (FPR) - Body Ground	10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 3: Identifying Fuel Pump Relay And ECM Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: REPLACE ECM  (See REMOVAL  )