Typical Enabling Conditions
TYPICAL ENABLING CONDITIONS
| The monitor will run whenever these DTCs are not present | P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (TP) |
| Time after ignition switch OFF to ON | 3 seconds or more |
| Engine | Running |
| Transmission counter gear speed | 300 RPM or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Either of the following conditions is met | Condition 1 Or 2 |
| 1. Both of the following conditions are met | Condition (a) or (b) |
| (a) ECT | 20°C (68°F) or more |
| (b) ECT sensor fail | Not detected |
| (c) Time after PNP switch ON to OFF | 10 seconds or more |
| 2. Both of the following conditions are met | Conditions (a) and (b) |
| (a) ECT | Less than 20°C (68°F) |
| (b) ECT sensor fail | Detected |
| (c) Time after PNP switch ON to OFF | 30 seconds or more |