LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 350 FWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel >> Fuel Pressure Pulsation Damper >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pressure Pulsation Damper: Installation

  1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY 
    1. Apply a light coat of spindle oil or gasoline to a new O-ring and install it to the fuel pressure pulsation damper.
      2. Fig 1: Identifying Fuel Pressure Pulsation Damper
      G04975030Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the fuel pressure pulsation damper to the fuel delivery pipe.
    3. Install the clip.
  2. INSTALL INTAKE AIR SURGE TANK ASSEMBLY  (See INSTALLATION )
  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  4. ADD ENGINE COOLANT  (See ON-VEHICLE INSPECTION )
  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL  (See INSTALLATION )
  6. CHECK FOR ENGINE COOLANT LEAKS  (See ON-VEHICLE INSPECTION )
  7. CHECK FOR FUEL LEAKS  (See ON-VEHICLE INSPECTION  )
  8. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY  (See INSTALLATION )
  9. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See INSTALLATION )
  10. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY 
  11. INSTALL FRONT FENDER TO COWL SIDE SEAL LH 
  12. INSTALL FRONT FENDER TO COWL SIDE SEAL RH 
  13. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See INSTALLATION )
  14. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See INSTALLATION )
  15. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  16. INSTALL ENGINE ROOM COVER SIDE  (See INSTALLATION )
  17. PERFORM INITIALIZATION 
    1. Perform initialization procedure (See INITIALIZATION ).

      HINT:

      Some systems need initialization after reconnecting the cable to the negative battery terminal.

scientia non olet · About LEMON Manuals