LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control >> Electronically Controlled Brake System >> Brake Control Warning Light does not Come ON >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

NOTE: When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (See INITIALIZATION ).
  1. INSPECT CAN COMMUNICATION SYSTEM 
    1. Check if the CAN communication system DTC is output (See DIAGNOSIS SYSTEM ).

    Result 

    RESULT CHART

    Condition Proceed To
    DTC is not output A
    DTC is output B

    B: REPAIR CAN COMMUNICATION SYSTEM 

    A: Go to next step 

  2. INSPECT MULTIPLEX COMMUNICATION SYSTEM 
    1. Check if the multiplex communication system DTC is output (See DTC CHECK / CLEAR ).

    Result 

    RESULT CHART

    Condition Proceed To
    DTC is not output A
    DTC is output B

    B: REPAIR MULTIPLEX COMMUNICATION SYSTEM 

    A: Go to next step 

  3. INSPECT BRAKE CONTROL WARNING LIGHT 
    1. Connect the intelligent tester to the DLC3.
    2. Turn the ignition switch on.
    3. Select the "ECB* WARN LAMP" in the ACTIVE TEST and operate the brake control warning light by the intelligent tester.

      ABS / VSC / TRAC: 

      VEHICLE CONDITION DIAGNOSTIC CHART

      Item (Display) Vehicle Condition/ Test Details Diagnostic Note
      ECB(1) WARN LAMP Turns brake control warning light ON/OFF Observe combination meter
      (1) Electronically Controlled Brake
    4. Check that "ON" and "OFF" of the brake control warning lights are indicated on the combination meter when using the intelligent tester.

      OK: The brake control warning lights turn on or off in accordance with the operation using the intelligent tester. 

      HINT:

      If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE ).

    NG: GO TO step   4 

    OK: REPLACE SKID CONTROL ECU 

  4. INSPECT COMBINATION METER ASSEMBLY 
    1. Check the combination meter assembly (See HOW TO PROCEED WITH TROUBLESHOOTING ).

      HINT:

      If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE ).

    NG: REPLACE COMBINATION METER ASSEMBLY 

    OK: END 

scientia non olet · About LEMON Manuals