Front Speed Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT SPEED SENSOR

Fig 1: Identifying Speed Sensor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Install the speed sensor onto the steering knuckle with the bolt.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  NOTE:
  - Check that the speed sensor tip and installation portion are free of foreign matter.
  - Install the speed sensor without turning it from its original installation angle.
2. Install the clamp onto the shock absorber with the bolt.
  Torque: 29 N*m (300 kgf*cm, 22 ft.*lbf)
3. Install the clamp onto the body with the bolt.
  Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
4. Install the 3 clips.
5. Connect the speed sensor connector.
6. Install the speed sensor clip onto the body.
INSTALL FRONT FENDER LINER
1. Install the front fender liner with the 3 screws, 6 clips and 4 grommets.
  NOTE: The speed sensor wire should not protrude beyond the front fender liner.
INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
CHECK ABS SENSOR SIGNAL
(See CHECK FOR INTERMITTENT PROBLEMS )