Inspection Procedure

1. Disconnect the P22 connector.
2. Measure the voltage and resistance according to the value (s) in the table below.

   Standard voltage 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Condition	Specified Condition
   P22-9 (CPUB) - Body ground	Always	10 to 14 V
   P22-10 (BDR) - Body ground	Always	10 to 14 V
   P22-20 (SIG) - Body ground	Ignition switch ON	10 to 14 V

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Condition	Specified Condition
   P22-2 (GND) - Body ground	Always	Below 1 Ω

Fig 1: Identifying Multiplex Network Master Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE