Brake Control Power Supply: Installation

INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY
1. Install the 2 brackets with the 4 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 1: Locating Brake Control Power Supply Assembly Brackets With Bolts
  Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. Install the brake control power supply assembly with the 3 nuts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 2: Locating Brake Control Power Supply Assembly Nuts
  Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3. Connect the brake control power supply assembly connector and install the clamp.
INSTALL DECK BOARD NO.1 CHECK
1. Install the deck board No.1 check with the 4 nuts.
INSTALL DECK SIDE TRIM BOX RH
INSTALL DECK SIDE TRIM BOX LH (See INSTALLATION )
INSTALL REAR FLOOR FINISH PLATE (See INSTALLATION )
INSTALL DECK NO.2 BOARD SUB-ASSEMBLY (See INSTALLATION )
INSTALL DECK NO.3 BOARD SUB-ASSEMBLY (See INSTALLATION )
INSTALL DECK FLOOR BOX REAR (See INSTALLATION )
INSTALL DECK FLOOR BOX FRONT (See INSTALLATION )
INSTALL DECK BOARD SUB-ASSEMBLY (See INSTALLATION )
CHECK AND CLEAR DTC
(See DTC CHECK / CLEAR )
PERFORM INITIALIZATION
Some systems need initialization after reconnecting the cable to the negative battery terminal.

(See INITIALIZATION )