Inspection Procedure

1. Disconnect the M6 panel connector.
   Fig 1: Identifying M6 Panel Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the N7 ECU connector.
3. Measure the resistance of the wire harness connectors.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Specified Condition
   M6-18 (MCO-) - N7-5 (MIC-)	Below 1 Ω
   M6-17 (MCO+) - N7-3 (MIC+)	Below 1 Ω
   M6-18 (MCO-) - Body ground	10 kΩ or higher
   M6-17 (MCO+) - Body ground	10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

OK: Go to next step 

1. Remove the instrument cluster finish panel center.
   Fig 2: Identifying Instrument Cluster Finish Panel Center Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance of the panel.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Specified Condition
   M6-18 (MCO-) - B-19 (MCO-)	Below 1 Ω
   M6-17 (MCO+) - B-18 (MCO-)	Below 1 Ω
   M6-16 (SGND) - 8-17 (SGND)	Below 1 Ω
   M6-18 (MCO-) - Body ground	10 kΩ or higher
   M6-17 (MCO+) - Body ground	10 kΩ or higher

NG: REPAIR OR REPLACE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE