Front Axle Hub Bolt: Replacement

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. REMOVE FRONT WHEEL 
2. DISCONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY 
   1. Remove the 2 bolts and disconnect the brake cylinder from the steering knuckle.
   2. Support the brake cylinder securely.
3. REMOVE FRONT BRAKE DISC 
   Fig 1: Locating Brake Cylinder To Steering Knuckle And Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. REMOVE FRONT AXLE HUB BOLT 
   1. Temporarily install 2 nuts to the hub bolts as shown in the illustration.
   2. Using SST and a brass bar or equivalent to hold the axle shaft, remove the hub bolt.

      SST 09628-10011 

      Fig 2: Installing Nuts To Hub Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. INSTALL FRONT AXLE HUB BOLT 
   1. Temporarily install a plate washer and nut to a new hub bolt as shown in the illustration.
   2. Using a brass bar or an equivalent to hold the axle, install the hub bolt by torquing the nut. Then remove the nut and plate washer.
   3. Remove the 2 nuts temporarily installed above.
6. INSTALL FRONT BRAKE DISC 
7. CONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY 
   1. Connect the brake cylinder to the steering knuckle with the 2 bolts.

      Torque: 118 N*m (1,203 kgf*cm, 87 ft.*lbf) 

      Fig 3: Installing Front Axle Hub Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. INSTALL FRONT WHEEL 
   1. Install the front wheel with the 5 nuts.

      Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)