Inspection Procedure

HINT:

Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P2119) 

   Result 

   RESULT CHART
   
   

   Display (DTC output)	Proceed to
   P2119	A
   P2119 and other DTCs	B

   B: GO TO RELEVANT DTC CHART 

   A: Go to next step 

2. CHECK IF DTC OUTPUT REOCCURS 
   1. Clear the DTC (see DTC CHECK/CLEAR  ).
   2. Allow the engine to idle for 15 seconds.
   3. Apply the parking brake and move the shift lever to the D position.
   4. Fully depress the brake pedal and the accelerator pedal for 5 seconds.

      HINT:

      Actual throttle position sensor voltage can be confirmed using the intelligent tester by entering the following menus: DATA LIST /ALL / THROTTLE POS #1.

      OK: 

      No DTC is output. 

   NG: REPLACE THROTTLE BODY 

   OK: NORMAL